廃油吸引器で吸引できないか、吸引が足りません。
- Causes: Oil temperature is too low. (min. 70°C).
- Remedy: Only suck hot oil. (70°C to 90°C).
廃油吸引器で吸引できません。
- Causes: Suction probe too short, clogged with dirt or bent.
- Remedy: Blow through suction probe if clogged with dirt.
計器検定対応の手動流量計に、線しか表示されません。
- Cause: Empty battery.
- Solution: Return the flow meter for battery replacement.
計器検定対応の手動流量計に、「エラー(Err)」が表示されます。
- Cause: direction of flow incorrectly set.
- Solution: calibration of the direction of flow.
電動オイルポンプの作動が止まりません。
- Cause: pump draws air through the suction line.
- Solution: unscrew the suction line, clean and re-seal it (sealing tape).
電動オイルポンプで圧力がかかりません。
- Cause: air in the system.
- Solution: unscrew oil gun from the pressure line. Put the hose into the barrel and let the pump run until oil is delivered.
栓を開いたときに、オイルが泡立ちます。
- Cause: leaky suction line.
- Solution: re-seal suction line.
電動オイルポンプがON/OFFを繰り返します。
- Causes: oil temperature has changed, e. g. because of heat or cold. Customer uses oil of higher or lower viscosity.
- Solution: bypass adjustment, call customer service. Customer will get setting instructions by fax.
ハンドレバーグリースガンからグリースが出ません。
- Cause: air in the cartridge or in the grease gun tube.
- Solution: open the grease gun tube by half a turn and vent it.
空圧式グリースポンプで圧力がかかりません。
- Causes: Air in the grease bucket, dented or conical bucket.
- Solution: remove the grease gun from the barrel and put it in a clean place. Firmly push the bucket on the soil several times to expel air from the grease. Push the follower plate down in the bucket until grease escapes in the middle of the follower plate. Now put the grease gun again in the bucket.
空圧式グリースポンプで圧力がかからず、作動が止まりません。
- Cause: dirt in the suction valve.
- Solution: call customer service. The customer will get an exploded view drawing. (Repair assistance)
ポンプで生成できる最大圧力は、どのくらいですか。
- Answer: In the case of a line pressure of 8 bar, the calculated delivery pressure is 400 bar.
空圧式オイルポンプの作動が止まりません。
- Cause: pump draws air through the suction line.
- Solution: unscrew the suction line, clean and re-seal it (sealing tape).
空圧式オイルポンプで圧力がかかりません。
- Cause: air in the system.
- Solution: unscrew the oil gun from the pressure line. Put the hose into the barrel and let the pump run until oil is delivered.
ポンプで生成できる最大圧力は、どのくらいですか。
- Answer: In the case of a line pressure of 8 bar, the calculated delivery pressure is 24 bar.
19 060および関連製品の不具合:吸引しません。
13 042および関連製品の不具合:吸引しません。